The matters needing attention in using light touch switch are introduced to you, especially the patch light touch switch. We need to pay attention to these problems when using them. Please read them carefully.

1. When welding the patch light touch switch terminal, if the load is applied on the terminal, it will be loosened, deformed and the electrical characteristics will deteriorate due to different conditions. Please pay attention to it when using.

2. When using through-hole PCB and PCB other than recommended, due to the influence of thermal stress will change, so please confirm the welding conditions in advance.

3. When welding twice, please do it after the first welding part is restored to normal temperature. Continuous heating may deform the periphery, loosen the terminals, drop off and reduce the electrical characteristics.

4. As for the setting of welding conditions, it is necessary to confirm the actual batch production conditions.

5. The product is designed and manufactured on the premise of DC resistance load. When using other loads [inductive load, capacitive load], please confirm separately.

6. Installation holes and modes of printed circuit boards, please refer to the recommended dimensions recorded in the product drawings.

7. Switch should be used for the structure of press switch directly operated by human. Please do not use for mechanical testing function.

8. When the patch touch switch is operated, if more than the specified load is applied, the switch will be damaged. Please be careful not to exert the above force on the switch.

9. Avoid using the operation section from the side.

10. For flat rod type, press the switch center as far as possible. For hinged structures, when pressed, the position of the axle rod will move. Please pay special attention to it.

11. After the switch is installed, please contact the professionals when it passes through the regenerative hardening furnace due to the hardening of the binder of other parts.

12. If corrosive gases are produced in the surrounding material of the whole machine using the switch, it may cause bad contact and other phenomena, so please make full confirmation in advance.

13. The carbon contact point has the characteristic of changing contact resistance due to push load. When used in voltage divider circuit, etc., please use it after full confirmation.

14. For models other than airtight ones, please pay attention to the invasion of foreign bodies.

Above are the problems needing attention in the use of light touch switch and patch clear switch. Please recognize us.